General-technologies FF300 Fault Finder for Electrical Wiring Open / Sh Manuale Utente

FF300 Electrical CircuitsFault FinderUser’s Handbook

1 - Check out listThe FF300 set consists of:o FF300R FaultFinder receiver.o FF300T FaultFinder transmitter.o Factory supplied 9- volt alkaline batter

Page 3Page 24 - Setting the sensitivity levelThe FF300R has three user selectable sensitivity ranges: ‘Low’, ‘Medium’ and ‘High’. These rang

Page 5Page 46.10 The short circuit is located in the area where the audio/visual signal stops or changes significantly.6.11 When the t

Fig.2 - Set up for tracing short or open circuits, or location of wiring Fig.3 - Set up for tracing short and open circuits, or tracing wiringFig.4

Page 9Page 812.3 Some circuit characteristics that may affect the tracing of a wire:• Electromagnetic loop size and geometry, etc. may affect the

Page 11Page 10This is achieved by means of connecting a jumper wire between the live wire (preferably at a termination point in the circuit such as a

Page 1215 - Care of the UnitThe FaultFinder is a precision instrument and should be treated as such. Damage caused by mistreatment is not covered by

Part # FF300M9909EN© 1999 General Technologies Corp.Printed in Canada